| (Paint) تجهیزات بازرسی رنگ و روکش
|
|
|
|
|
|
|
Surface Roughness - Testex Gauge - R1004 / R2004
|
| "Product PDF" |
The Testex Gauge is used to measure the Testex Tape and determine the average maximum peak-to-valley height of the blasted profile.
Measurements are made by firstly zeroing the gauge on 50µm (2mils). This is to allow for the film backing. Place the replicated area between the anvils and gently lower the moveable anvil onto the film. The reading can now be taken, giving you the average peak-to-valley height of the blasted profile.
Complies with International Standards: ISO DIS 8503-3, BS 7079-C5,
ASTM D 4417-C and NACE RP 0287-95.
Calibration Certificate with traceability to UKAS is an optional extra. The Certificate is supplied in a paper format and is available online through the Calibration Portal (under Browse Categories) on this website. The Calibration Portal will list all your equipment that is calibrated by Paint Test Equipment, showing the renewal dates and allowing Calibration Certificates to be viewed at any time.
Supplied in a Foam-Filled Carrying Case with 1 roll of Coarse Testex, 1 roll of X Coarse Testex and a Burnishing Tool. |
|
|
|
|
|
| |